Elastix NLX400 and OpenVox D130E Issue
-
Hi All,
I am new to Elastix .We have Elastix NLX400 and OpenVox D130P T1/E1/J1 PCI card.
I have installed the OpenVox D130E in Elastix NLX400 and done a hardware detected from elastix web UI. The card was detected but its shows **Detected by Asterisk **and unknown .Also configuration of span is only showing there,no parameters of span .
As troubleshooting this issue i have configured the Dahdi as per the link
http://wiki.openvox.cn/index.php/OpenVox_D130P_Dahdi_en
After this the unknown status change to PRI and parameter of span also appeared but it shows Not detected by Asterisk
Please help me to configure the OpenVox D130P. If any document for step by step installation please share me.
-
If you have an NLX400, doesn't that come with commercial support? Why get Elastix on an appliance?
-
@scottalanmiller said:
Why get Elastix on an applianc
It Doesn't have a commercial support currently . This appliance was brought by our branch office and no idea why Elastix on an appliance purchased.
currently we want to configure this device to have outgoing through PRI line.
-
Hi,
NXL4000 was installed with Elastix 2.4 . I have upgraded the Elastix to 2.5 and the issue get resolved.
Thanks all for the support
-
Well that's good
Always best to start with updating before setting anything up or testing because you don't know what problems are already resolved and you might miss new problems that haven't existed yet. -
@scottalanmiller said:
you don't know what problems are already resolved and you might miss new problems
Yes i agree with that.
