@JaredBusch said in Yealink T46S Double Tap while on Conference call:

@CCWTech said in Yealink T46S Double Tap while on Conference call:

@JaredBusch said in Yealink T46S Double Tap while on Conference call:

DTMF

Is that on the ext in advanced? It's set to RFC4733

Both the Phone and Asterisk have settings for this. They need to match.

They do, we checked that last night.

@JaredBusch said in Make Yealink Ring While on the Phone:

@scottalanmiller said in Make Yealink Ring While on the Phone:

If you have Yealink T46S phone, and you are talking on the phone, instead of making it do a call waiting beep, can you make it ring normally? A bit odd, but there is a reason for it 🙂

Not to my knowledge.

It was supposedly added as a feature request a few years ago, and I have not noticed it in a firmware release note.

That would explain why I have never seen it come up. Not that anyone has ever wanted it previously.

@JaredBusch - The Endpoint Manager has it Enabled. I set it as disabled to match your settings to see if that fixes it. I will report back later with the results. As always thank you for your assistance.

@jaredbusch said in SIP Desk Phones Not Re-Registering with Main WAN's IP After WAN Fail-back:

@scottalanmiller said in SIP Desk Phones Not Re-Registering with Main WAN's IP After WAN Fail-back:

@taurex said in SIP Desk Phones Not Re-Registering with Main WAN's IP After WAN Fail-back:

@jaredbusch Thanks for this link. I'll give it a try. I hope UBNT did not trim the CLI down too much on the USG. I now better understand why Edge series is still the prefered choice for deployment among many🙂

Especially now that UNMS is available, that's pretty slick.

UNMS 0.12.0 (currenlty in alpha) will add the CLI to the web interface.

That's very exciting. So much good stuff happening with UNMS.

@dashrender said in Yealink phone answer when headset button pressed:

/sigh...

That was it. The instructions don't say anything to remind a person to look at the dipswitches....

It is in the manual.